 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Servo drive spec for EMC2 use
Having now tested my servos on the Shizuoka and found all working, I now
need to spec some servo drives. If I understand correctly, EMC can output from the PC, (via a D/A card?), the necessary +/_10V analogue control signals for the servo drive. Would then these be suitable assuming that the rating is suited for my motor volts/current? http://www.mclennan.co.uk/datasheets...wamplifier.pdf I'll look into the encoders later this week. Many thanks. JB |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Weird behavior of servo motor drive | Metalworking | |||
| Servo drive failed | Metalworking | |||
| AMC DC Servo drive adjustments explained | Metalworking | |||
| Wired Z axis servo drive | Metalworking | |||
| Ran a motor with servo drive today | Metalworking | |||
Threaded Mode
