On 2011-03-14, JB wrote:
Having now tested my servos on the Shizuoka and found all working, I now
need to spec some servo drives. If I understand correctly, EMC can output
from the PC, (via a D/A card?), the necessary +/_10V analogue control
signals for the servo drive.
Would then these be suitable assuming that the rating is suited for my motor
volts/current?
http://www.mclennan.co.uk/datasheets...wamplifier.pdf
I'll look into the encoders later this week.
Many thanks.
JB

PMD60 or DCD60 10/20 or 14/28 should work pretty well.

I have AMC 30A8 on all my five axes. They are similar to those
14/28. And they work great. Just a data point.

i