Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
DIY crow's foot wrench
Having just put a new thermocouple in a water heater and without my
crow's feet[which would probably been too big for the job]. question 1 does any one make 1/4" drive crow's feet? question 2 If I were to heat a combination wrench with the oxy torch and bend the open end to 90 deg would I have to re temper, heat treat,or??? Thanks in advance. Chuck P. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
ok, what is this wrench really? | Metalworking | |||
re-occuring end wrench | Metalworking | |||
hot wrench | Metalworking | |||
Where can I get a wrench like this? | Metalworking | |||
New type of wrench | UK diy |