On Thu, 18 Dec 2008 19:50:24 -0800, Pilgrim
wrote:

Having just put a new thermocouple in a water heater and without my
crow's feet[which would probably been too big for the job].
question 1 does any one make 1/4" drive crow's feet?
question 2 If I were to heat a combination wrench with the oxy torch and
bend the open end to 90 deg would I have to re temper, heat treat,or???

Thanks in advance.

Chuck P.

Q1 - Look at Snap-On Tools "Weatherhead" sockets, and if that will
work , buy a much less expensive deep socket and grind to match!

Bob