Home |
Search |
Today's Posts |
|
Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to alt.home.repair
|
|||
|
|||
remove barbed fitting from irrigation tubing
I have a piece of 160 PSI irrigation tubing. OD a hair over an inch, ID just a bit over 3/4.
It broke at a connection. Well, the barbed connector fitting broke in half. It would be easy to replace, except I can't get the old one out. I don't want to shorten the tubing, as it's the right length now, or I would just cut each end and start over. I could do that and insert a piece, but I would have to buy a 100 foot roll. Is there any good way to do this? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Sell:Brass Male Adapter,Swivel Female Adapter,Flare Adapter,Tee,Connector,Barbed Tee,Elbow, | Home Repair | |||
Barbed Wire supplier ? | UK diy | |||
Stainless barbed insert adapter sizing?? | Metalworking | |||
Any suggestions where to get brass barbed fittings? | UK diy | |||
Barbed/Slot Hinge Gotcha | Woodworking |