All the fittings and tubing you ever wanted. Brass, stainless, etc.

https://www.mcmaster.com/#Standard-S...s-Steel-Tubing


"TimR" wrote in message ...
I have a piece of 160 PSI irrigation tubing. OD a hair over an inch, ID just a bit over 3/4.

It broke at a connection. Well, the barbed connector fitting broke in half.

It would be easy to replace, except I can't get the old one out.

I don't want to shorten the tubing, as it's the right length now, or I would just cut each end and start over. I could do that and insert a piece, but I would have to buy a 100 foot roll.

Is there any good way to do this?