I finally got my wire ran from building to building. Unfortunately, I
think one or two of my joints (conduit to conduit) may not have fully
seated when installing them. (PVC) I had trouble when installign the
conduit of pulling one piece fully inot the other matting piece in the
ditch . It is on and glued but I am not sure each pipe "bottomed out"
into the other pipe if that makes sense.

Would putting concrete over the joint make it more water/moisture
proof or am I worrying for nothing?

Yes, that makes total sense, to me. I'm not sure about the
concrete. I'd be tempted to blob on generous ammounts of PVC
glue, and let that dry. Hope that does the job.

--
Christopher A. Young
Learn more about Jesus
www.lds.org
..


"stryped" wrote in message
...
I finally got my wire ran from building to building.
Unfortunately, I
think one or two of my joints (conduit to conduit) may not
have fully
seated when installing them. (PVC) I had trouble when
installign the
conduit of pulling one piece fully inot the other matting
piece in the
ditch . It is on and glued but I am not sure each pipe
"bottomed out"
into the other pipe if that makes sense.

Would putting concrete over the joint make it more
water/moisture
proof or am I worrying for nothing?

"Stormin Mormon" wrote in message
...
Yes, that makes total sense, to me. I'm not sure about the
concrete. I'd be tempted to blob on generous ammounts of PVC
glue, and let that dry. Hope that does the job.

As long as it is a non traffic area maybe, but PVC cement softens the
plastic. Globbing massive amounts on the outside could cause excessive
softening and result in damage.

Thanks for the field report. Didn't know that.

--
Christopher A. Young
Learn more about Jesus
www.lds.org
..


"Bob La Londe" wrote in message
...


"Stormin Mormon" wrote
in message
...
Yes, that makes total sense, to me. I'm not sure about the
concrete. I'd be tempted to blob on generous ammounts of
PVC
glue, and let that dry. Hope that does the job.

As long as it is a non traffic area maybe, but PVC cement
softens the
plastic. Globbing massive amounts on the outside could
cause excessive
softening and result in damage.