Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Source for material?
Need about a 5 ft chunk of 8mm OD stainless round, with a hole through the
center lengthwise. Hole size not critical, somewhere in the range of 1.5 to 2.5 mm. I've checked out gun drilling sources, but they seem to top out around 200x diameter for length of hole. This is more like 600x. Metric stainless DOM? No idea of the alloy, but it's pretty springy. 304? 312? 316? 5/16" would probably work, but the original is definitely metric. Anybody have a source, or just a suggestion of where to look? Thanks, Bill |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Source for material?
Bill Marrs wrote:
Need about a 5 ft chunk of 8mm OD stainless round, with a hole through the center lengthwise. Hole size not critical, somewhere in the range of 1.5 to 2.5 mm. I've checked out gun drilling sources, but they seem to top out around 200x diameter for length of hole. This is more like 600x. Metric stainless DOM? No idea of the alloy, but it's pretty springy. 304? 312? 316? 5/16" would probably work, but the original is definitely metric. Anybody have a source, or just a suggestion of where to look? Thanks, Bill Look for heavy walled seamless tube .. |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
Source for material?
In article d7FPf.28677$W42.16896@trnddc02,
says... Need about a 5 ft chunk of 8mm OD stainless round, with a hole through the center lengthwise. Hole size not critical, somewhere in the range of 1.5 to 2.5 mm. I've checked out gun drilling sources, but they seem to top out around 200x diameter for length of hole. This is more like 600x. Metric stainless DOM? No idea of the alloy, but it's pretty springy. 304? 312? 316? 5/16" would probably work, but the original is definitely metric. Anybody have a source, or just a suggestion of where to look? http://www.microgroup.com/materials_...&F3=&F4=2&F1=1 &F5=Stainless+Steel&F6=&F7=&F8= Ned Simmons |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Question regarding FET with low Drain to Source capacitance - FET_termination.jpg (0/1) | Electronics | |||
Correct to -- Question regarding FET with low Drain to Source capacitance - FET_termination.jpg (0/1) | Electronics | |||
Try this Gunner | Metalworking | |||
OT - Delay, Delay | Metalworking |