Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Emerson Horizon 1 VFD info request
I just finished installing an Emerson Horizon 1 singlephase to 3phase
VFD on my big Delta drillpress. Its only rated for 1/2 hp, but runs the 3/4hp motor just fine, even when I stuffed a 2MT 1" bit into the quill and burned through a chunk of HRS at low rpms. Mine has a blanked position for "reverse" and no obvious terminals inside, plus there is a second set of terminals that indicate a switch goes across them..and there is a jumper there..but they dont seem to do anything. Anyone have a manual and can give me a clue on how to wire in a reverse switch and what the jumpered pair is for? And yes..Ive checked the net. Thanks Gunner "Pax Americana is a philosophy. Hardly an empire. Making sure other people play nice and dont kill each other (and us) off in job lots is hardly empire building, particularly when you give them self determination under "play nice" rules. Think of it as having your older brother knock the **** out of you for torturing the cat." Gunner |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Miller 35 wirefeed welder info request | Metalworking | |||
Airco 300 Square Wave info request | Metalworking | |||
Info request - Building home | Home Ownership | |||
Clausing 8540 Horiz Mill info request | Metalworking | |||
Request for info: AN6516N IC | Electronics Repair |