Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
DVD Media Player Drive Belt Replacement
I have a DVD Media Player Drive sd-6100ku Toshiba with a slipping DVD
door opening drive belt. The door will open if I give it a slight push from inside the unit. I looked at using an O-Ring but the ones I find are too fat and just do not fit. I looked on line for some kind of drive belt kit but was unable to match up with the belt I have. The belt is approximately: 3 cm diameter 2mm thick with a square cross-section. Is there an easy fix? Or any fix --- news://freenews.netfront.net/ - complaints: --- |
#2
Posted to sci.electronics.repair
|
|||
|
|||
DVD Media Player Drive Belt Replacement
On 21/05/2015 16:39, OldGuy wrote:
I have a DVD Media Player Drive sd-6100ku Toshiba with a slipping DVD door opening drive belt. The door will open if I give it a slight push from inside the unit. I looked at using an O-Ring but the ones I find are too fat and just do not fit. I looked on line for some kind of drive belt kit but was unable to match up with the belt I have. The belt is approximately: 3 cm diameter 2mm thick with a square cross-section. Is there an easy fix? Or any fix --- news://freenews.netfront.net/ - complaints: --- Get one of these http://www.dx.com/p/m-fun-mel0292-mi...l-green-175693 slice up into rings and then slice an appropriate ring down to something like the cross-section needed. As no audio quality issue involved (wow/flutter) you don't need to slice up with any precision. With practise and the right techhnique you can slice these funnels to flat bands as well as square. |
#3
Posted to sci.electronics.repair
|
|||
|
|||
DVD Media Player Drive Belt Replacement
On Thu, 21 May 2015, OldGuy wrote:
I have a DVD Media Player Drive sd-6100ku Toshiba with a slipping DVD door opening drive belt. The door will open if I give it a slight push from inside the unit. I looked at using an O-Ring but the ones I find are too fat and just do not fit. I looked on line for some kind of drive belt kit but was unable to match up with the belt I have. The belt is approximately: 3 cm diameter 2mm thick with a square cross-section. Is there an easy fix? Or any fix No. But an important consideration is that anything that works will do. Since this is just closing and opening the drawer, uneveness will not be a factor. If this was driving the disk (or driving the turntable in a turntable), any uneveness would get into the sound (well maybe not with a CD player). There you need a legit belt. Here, cutting an elastic band, if you can find one close, would be fine. Michael |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Need help making special drive belt installation tool for 371 PorterCable belt sander | Metalworking | |||
Drive belt source for 1980's hi-fi casette player wanted | UK diy | |||
Sony Blu-Ray player drive replacement | Electronics Repair | |||
Dryer's replacement drum/drive belt has only 4 ribs - is that OK? | Home Repair | |||
How to install new drive belt...Ryobi BE-321 3x21 belt sander | Woodworking |