Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Honing guide measurements?
Millimeters = equals degrees with the most basic vise type of guide, bought mine at a Rockler store. The instructions only give the following: Chisel projection: 30mm = 30º / 40mm = 25º Plane iron projection: 38mm = 30º / 50mm = 25º Time for 1º more for the micro bevel of either, can anyone tell me how many less millimeters to subtract from the projections? -- Alex cravdraa_at-yahoo_dot-com not my site: http://www.e-sword.net/ |
#2
|
|||
|
|||
It ought to me accurate enuf to interpolate:
-2 mm for chisels and -2.5 mm for plane irons should give you a 1degree change. Walt C "AAvK" wrote in message news:Qi1Xd.8941$qf7.416@fed1read03... Millimeters = equals degrees with the most basic vise type of guide, bought mine at a Rockler store. The instructions only give the following: Chisel projection: 30mm = 30º / 40mm = 25º Plane iron projection: 38mm = 30º / 50mm = 25º Time for 1º more for the micro bevel of either, can anyone tell me how many less millimeters to subtract from the projections? -- Alex cravdraa_at-yahoo_dot-com not my site: http://www.e-sword.net/ |
#3
|
|||
|
|||
It ought to me accurate enuf to interpolate: -2 mm for chisels and -2.5 mm for plane irons should give you a 1degree change. Walt C Really cool, thanks Walt! -- Alex cravdraa_at-yahoo_dot-com not my site: http://www.e-sword.net/ |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Veritas low angle block plane | Woodworking | |||
Cutting oil? honing oil? whats the difference? | Metalworking | |||
Question about building saw guide | Woodworking | |||
Laser guide question | Woodworking | |||
Fisher cassette heads | Electronics Repair |