I am getting ready to tool up a shaper for pattern cutting. Edging
chair legs, arched end-table spreaders, etc. I want to get a big
cutter 3 or 4 inch diameter with a rub coller. I like the idea of
using these rabbeting cutters with a single long insert blade. I'll
just leave off the rabbet bottom cutters when doing full depth pattern
cutting. Cheap and easy to replace the blades and a nice cut I
suppose, I never liked the nibble of little carbides.

Does anyone have any experience with any of these. On the Amana's I am
interested in both the shear and cheaper (smaller) cutter.

http://www.infinitytools.com/products.asp?dept=1249

http://www.toolstoday.com/c-450-insert-rabbeting.aspx

SonomaProducts.com wrote:
I am getting ready to tool up a shaper for pattern cutting. Edging
chair legs, arched end-table spreaders, etc. I want to get a big
cutter 3 or 4 inch diameter with a rub coller. I like the idea of
using these rabbeting cutters with a single long insert blade. I'll
just leave off the rabbet bottom cutters when doing full depth pattern
cutting. Cheap and easy to replace the blades and a nice cut I
suppose, I never liked the nibble of little carbides.

Does anyone have any experience with any of these. On the Amana's I am
interested in both the shear and cheaper (smaller) cutter.

http://www.infinitytools.com/products.asp?dept=1249

http://www.toolstoday.com/c-450-insert-rabbeting.aspx

I have used the Amana cutters with both the straight and shear knives.
They both produced a very clean cut run at a low noise level. The
nickers are important/essential to the quality of the cut.

Haven't used this particular slot cutter, but have used the Felder 8"
slot cutter. Terrific results on both slots and tenon cheeks.

This was on a Felder shaper.

Jim