Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
how to sharpen mini dike cutters, nipper cutters?
I have used a very thin file to touch up these tools . it takes a bit of
skill to hold the file steady but it can be done . If you can set the tool in a vice you can also use a dremel tool with a cut off wheel . The cut off wheel is super thin but once again it takes good skill to set the spinning wheel on the blade & get it streight . Dont draw the wheel across the blade .. lay it fully on the blade and hold it so it does the entire blade edge in one shot . |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
how to sharpen mini dike cutters, nipper cutters? | Metalworking | |||
sharpen Woodruff cutters | Metalworking |