Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
Table saw motor clicking loudly under load
Hi. It's me again. I'm still fussing with my table saw after replacing
the belt. The pulley stays in place now, I think thanks to a good cleaning. But no matter where I position it on the shaft, I hear a loud clicking when the motor is running. I think (but I can't be 100% sure) that the sound is coming from the motor and not the saw arbor. If I run the motor without the belt it runs smoothly. This is a 2hp motor and a Rexon RW10 table saw. I bought it in 1993. Do you think one of the motor bearings needs replacing? What's normal for wear and tear? Sure it's been 14 years, but it probably only sees a few hours of duty per month. I hope I don't have to shell out $300 for a new motor! - Owen - |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Help--Table Saw motor changes speed ! | Woodworking | |||
unisaw motor load | Woodworking | |||
Replace Jet Table Saw Motor.... Help! :) | Woodworking | |||
table saw motor problem | Woodworking | |||
IDE Hard Drive motor clicking-- any chance of getting my data off? | Electronics Repair |