Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
TS Motor stopping periodically.
Hi,
maybe someone could suggest what is going on with my TS lately. I have an older Beaver contractors table saw. which has a 3/4 110 v motor and a magnetic switch. When I use the saw with a standard rip or combination blade it runs fine. But, if I use a dado blade after a while the motor shuts off. If I try to start it right away it won't start. If I wait a minute it will start and then shut down immediately. If I wait a few minutes it starts up again and then runs fine for a while and then the whole process repeats itself. Is the motor overheating? I'm not doing a lot of cutting with it. Thanks Alex |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Combi periodically cuts out on DHW | UK diy | |||
TFT screen blanks periodically | Electronics Repair | |||
Philips LTC2810 periodically bad colours | Electronics Repair | |||
Hotpoint Fridge 1998 Stops Periodically with Period in Months. | Home Repair | |||
stopping a diesel | Metalworking |