Hi,

maybe someone could suggest what is going on with my TS lately. I have
an older Beaver contractors table saw. which has a 3/4 110 v motor and
a magnetic switch.

When I use the saw with a standard rip or combination blade it runs
fine. But, if I use a dado blade after a while the motor shuts off. If
I try to start it right away it won't start. If I wait a minute it
will start and then shut down immediately. If I wait a few minutes it
starts up again and then runs fine for a while and then the whole
process repeats itself.

Is the motor overheating? I'm not doing a lot of cutting with it.

Thanks

Alex