good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm
for fine finish cutting in mdf and ply,can you advise what i should be
looking for teeth wise,kind regards and thanks,Bob

In an earlier contribution to this discussion, bob
wrote:
good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm
for fine finish cutting in mdf and ply,can you advise what i should be
looking for teeth wise,kind regards and thanks,Bob


I would have thought that something like this would probably do the job:
http://www.screwfix.com/prods/90408/...0T-190x16-30mm
--
Cheers,
Roger
_______
Please reply to Newsgroup. Whilst email address is valid, it is seldom
checked.

Roger Mills
wibbled on Friday 12 February 2010 17:30

In an earlier contribution to this discussion, bob
wrote:
good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm
for fine finish cutting in mdf and ply,can you advise what i should be
looking for teeth wise,kind regards and thanks,Bob


I would have thought that something like this would probably do the job:
http://www.screwfix.com/prods/90408/...-Circular-Saw-
Blades/Erbauer-TCT-Saw-Blades/Erbauer-TCT-Circular-Saw-Blade-40T-190x16-30mm

That looks a similar tooth count to the TCT blade I have. Although it looks
course, it does actually cut quite nicely with minimal splintering
(virtually none if you're lucky).

--
Tim Watts

Managers, politicians and environmentalists: Nature's carbon buffer.

bob wrote:
good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm
for fine finish cutting in mdf and ply,can you advise what i should be
looking for teeth wise,kind regards and thanks,Bob

Go for minimum 40 teeth. Best place to buy IME
http://www.itslondon.co.uk/p2_PTA_Po...Saw+Blades.htm



--
Dave - The Medway Handyman
www.medwayhandyman.co.uk

"bob" wrote in message
...
good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm
for fine finish cutting in mdf and ply,can you advise what i should be
looking for teeth wise,kind regards and thanks,Bob


if it's MDF then you need TCT with minimum offset.