Hi;
When using banjo bolts,do you have to align the internal holes up with
the tubing that feeds it or does the mating connector have room on its
circumference for the fluid to travel ?
Regards
My98tj

In article .com,
wrote:

When using banjo bolts,do you have to align the internal holes up with
the tubing that feeds it or does the mating connector have room on its
circumference for the fluid to travel ?

No need for aligning the holes. Most (all?) banjo fittings have a groove
or hollow on the inner face to provide a fluid path to the holes in the
bolt that holds it down.

--
Don Bruder - - New Email policy in effect as of Feb. 21, 2004.
Short form: I'm trashing EVERY E-mail that doesn't contain a password in the
subject unless it comes from a "whitelisted" (pre-approved by me) address.
See http://www.sonic.net/~dakidd/main/contact.html for full details.