Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Indicator stand question, and vernier height guage question - repairs
G'Day, long story short, I've obtained one of each of these in various states of neglect and disrepair. I've decided to try rebuilding them back to their operational state. The Magbase indicator stand - the main post would be threaded into the magnetic baseeffectively bridging the two poles. If I make this post from Steel (magnetic) will this pose an issue for weakening the holding field? What are these posts typically made off, and what dimensions are they typically? I have measured the thread as Metric 8mm coarse, but that's all I know at this stage. The vernier height guage. The one I saved is a Mitoyu with an adjustable 300mm ruler, vernier on the slide, and a few other controls. There is minor cosmetic damage here and there, including some damaged screws, but those I can fix easy enough. What is missing is the clamp, and "pointy bit" which is attached to the sliding component. This tool appears on the cover of "The machinist's bedside reader #2", and the "pointy bit" appears to be a sharp edged piece - either for scribing, or perhaps for feeling an edge. Is there an online reference which shows how to use this tool, and what the pointy bit is used for? If for scribing, I was planning on reproducing the missing part from HSS, but if this is an issue, please tell me what it should be for, and made of. thanks, Des Remove the german antispam device from my return address if emailling me. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Installing a Wixey Planer Height Guage | Woodworking | |||
Enclosed digital height guage? | Metalworking | |||
Oil tank indicator question (a different one) | UK diy | |||
Oil Tank indicator question | UK diy | |||
Question about Mitutoyo Pocket Test Indicator | Metalworking |