Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#11
Posted to rec.crafts.metalworking
|
|||
|
|||
ceramic tile and mild steel
"cj" wrote in message ... greetings, i am planning on making a small table for our deck and i would like to use a mosaic tile pattern for the table top so i thought that i would make a pan out of 16 ga., turn it up side down and tack it to the inside of the table frame, therefore giving me a flat surface to put the tile in, and keep it flush with the top of the frame. now i am wondering what kind of adhesive would work best to affix the tile(3/4 inch tiles sheets with a mesh backing) to the 16 ga. the frame will be made if 3/4 square tubing that i will have powdercoated any comments would be appreciated,cj My daughter and I were working on a similar table yesterday. The table came with the house when we moved in. It appears to be commercially made. It has a sheet metal pan about an inch deep that was filled with concrete, tile was set on the concrete It was much abbused but structurally sound. It is heavily galvanized and has been outside in the rain and humidity in Central Florida for the 17 years I have been here with NO rust. We had previously removed the old tile and concrete, and yesterday's effort was to mix up 2 bags of concrete mix and apply. We crowned the surface slightly (1/8" in 30" span) so that rain will run off. We will apply the tile with thinset mortor and seal the grout. With out the galvanizing I would worry about rust as other folks have pointed out. Carl Boyd |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Welding SS to mild steel | UK diy | |||
rebar - why is mild steel okay? | UK diy | |||
Simple finish on mild steel | Metalworking | |||
mild steel question | Metalworking | |||
Source for mild steel strip? | Metalworking |