Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Need Anilam Wizard Manual or info
I just purchased an old Anilam Wizard, model 112-2 (cheap) on eBay. It seems
to work ok but the only manual I can find is for the later models, Mini and Micro Wizard units. Maybe over time I can figure this thing out but for right now I'd like to get it into the diagnostic mod and see if the processor,etc. are working properly.. I should mention that I didn't get any encoders with the unit and can't check the input right now. The diagnostic should be able to run without the encoders. Also, there are a pair of thumb wheel numeric input 'thingies' on the back but no labels or reference in the manual I have. (not shown in the illustration of the back of these later units) Thanks for any help I can get. Steve |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Grizzly DRO manual | Metalworking | |||
f38310 service manual | Electronics Repair | |||
Lorch Junior lathe slide rest info? | Metalworking | |||
Clausing 8540 Horiz Mill info request | Metalworking | |||
Brown & Sharpe surface grinder info | Metalworking |