DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Metalworking (https://www.diybanter.com/metalworking/)
-   -   Need Anilam Wizard Manual or info (https://www.diybanter.com/metalworking/136790-need-anilam-wizard-manual-info.html)

Steve December 23rd 05 12:22 AM

Need Anilam Wizard Manual or info
 
I just purchased an old Anilam Wizard, model 112-2 (cheap) on eBay. It seems
to work ok but the only manual I can find is for the later models, Mini and
Micro Wizard units.

Maybe over time I can figure this thing out but for right now I'd like to
get it into the diagnostic mod and see if the processor,etc. are working
properly..

I should mention that I didn't get any encoders with the unit and can't
check the input right now. The diagnostic should be able to run without the
encoders.

Also, there are a pair of thumb wheel numeric input 'thingies' on the back
but no labels or reference in the manual I have. (not shown in the
illustration of the back of these later units)

Thanks for any help I can get.

Steve




All times are GMT +1. The time now is 08:28 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter