Not sure how long a bar should last. I've sharpened the chains many
times now and it seems great. Just wondering how long bars last and how
it will show itself.

Thanks!

Dean

"dean" wrote in message
oups.com...
Not sure how long a bar should last. I've sharpened the chains many
times now and it seems great. Just wondering how long bars last and how
it will show itself.

Thanks!

Dean


I know very little about this, but will share what I just read in my new
Husky instruction and safety manual. The bar will start becoming mushroom
shaped when looked at from the end with no chain in it. Also, remove the
chain and bar, and rub your fingertips lightly FROM THE CENTER OUTWARD. If
you feel a lip on the outer edge of the bar, it is worn. BE CAREFUL, as you
can cut your fingers. They say to just file it flat again. If it is worn
too much, the chain won't seat in there, and you will see a small space
between the chain and the bar.

They said to turn the bar over EVERY DAY to get it to wear evenly

Steve

SteveB wrote:




I know very little about this,

As usual...

Dean,

When the bottom of the chain hits the bottom of the bar channel or the
two channels on the bar wear down allowing the chain to ride not
touching the bar then its time to get a new one. Can't say by time wise
because it depends on friction, proper use of oil, etc. A worn bar will
cause the chain to go bad quicker.



dean wrote:
Not sure how long a bar should last. I've sharpened the chains many
times now and it seems great. Just wondering how long bars last and how
it will show itself.

Thanks!

Dean

The other thing to watch for is the bar wearing unevenly from side to side.
This will make cuts go off a straight line and start to curve.
Also watch for 'bluing', the discoloration of the bar because of
overheating caused by underoiling.

Charlie

"Joey" wrote in message
...
Dean,

When the bottom of the chain hits the bottom of the bar channel or the two
channels on the bar wear down allowing the chain to ride not touching the
bar then its time to get a new one. Can't say by time wise because it
depends on friction, proper use of oil, etc. A worn bar will cause the
chain to go bad quicker.



dean wrote:
Not sure how long a bar should last. I've sharpened the chains many
times now and it seems great. Just wondering how long bars last and how
it will show itself. Thanks!

Dean

IME, until the sprocket bearing (in the tip) fails. With proper
sharpening and chain-lube.

Dull chain really shortens bar life; ditto lack of lube.

Cutters dulled on one side (e.g. from stone contact) can wear one side
of rail, making chain sit at an angle. Then you have a circle-cutter.
Pretty easy to check and true-up, so long as groove is deep enough to
let chain sit on rails after.

HTH,
J