Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
a
 
Posts: n/a
Default Security Code on Kenwood CD player

I bought a Kenwood CD player from a pawn shop last week and it has a
security code on it. The pawn shop doesn't have the code and kenwood
says i need to have the original reciepts to have them reset it.
I was wondering if anyone know's how to reset this CD player?
It is a Excelon modem KDC-X559 car cd player.


thanx!!

  #2   Report Post  
Marcus
 
Posts: n/a
Default Security Code on Kenwood CD player

Wrap it in several layers of cling film and leave it in the freezer for a
few days.

--
Regards
Marcus


  #3   Report Post  
L1ange bleu
 
Posts: n/a
Default Security Code on Kenwood CD player

I'm just curious...would you please let me know if you find out how to reset
those codes?
Alphie
  #4   Report Post  
a
 
Posts: n/a
Default Security Code on Kenwood CD player

will the seriously work?

i haven't found anything except "take it to an authorized repair center" for
an answer when searching.


also, if that's not a good answer or doesn't work, will the service manual
have the info i need to reset it?


thank you.

Marcus wrote:

Wrap it in several layers of cling film and leave it in the freezer for a
few days.

--
Regards
Marcus


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
CD player problem... scott Electronics Repair 7 October 27th 03 08:46 PM
Kenwood RXD-A53 Scott Gibson Electronics Repair 0 October 10th 03 01:09 AM
Security Systems Bob Swinney Metalworking 33 September 19th 03 07:51 AM
recmd to mark steel part with changing lot code? William Danielson Metalworking 4 July 1st 03 01:57 PM


All times are GMT +1. The time now is 07:54 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"