Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
RCA 27" T.V. stby ok...but won't start.
RCA Model # F27665YX1 Chassis # CTC203AX, with onboard tuner, & one
ribbon Gemstar module, dead, nothing blown, standby voltages ok. + 139 volt,+ 33 volt, - 11.9 volt, + 2.4 volt, & + 5 volt are all ok, but no + 12 volt input to U14104. At startup, as the unit tries three times to come on, I get about + 7 volts that momentarily comes up, & drops right away. Even with a low current source applied to U14104, the unit won't start. I replaced the flyback with a "known good one". I don't have a "known good" Gemstar module, but I took it out, & tried another one, still no go. Cr 14701 flyback secondary was the cause of a set with a similar problem, but this one got me stumped. Any ideas anyone? Thanks, Dani. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
RCA D52W20 fails to start | Electronics Repair | |||
HDTV RCA D52W19 SHUTS DOWN BEFORE START UP | Electronics Repair | |||
pallet jack, "the oil change scenario", where's it start? (semi-exciting) | Metalworking | |||
Akai AC-300 Audio Sys. won't power on from Stby. | Electronics Repair | |||
RCA CTC203 won't start | Electronics Repair |