Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
BoborAnn
 
Posts: n/a
Default Eveready W-353 Battery Any info or sources available?

I am repairing a Simpson model 1699 precision milliohm meter and found one
of these batteries in it. There was also a standard 9 Volt Battery which
leads me to believe the unit is 20-30 years old.
I've searched everywhere and can't find any info on this battery and was
hoping someone could advise what its characteristics were and why someone
would use this versus a standard D cell in this application.
Its about 1 1/4 X2 1/4 X 4 Inches and 1.5 V and bears no date code
This is a great meter and I'd like to find the right battery and not need
adapt a D Cell
Thanks in Advance
Bob


  #2   Report Post  
Tim Schwartz
 
Posts: n/a
Default

Bob,

I've got a "Eveready Battery Engineering Data, Vol. III, 1984" book,
and **THAT** shows the W353 as discontinued. There is not much about it
other than its is an ANSI/NEDA 11, IEC R25-2 or a military BA802/U. the
dimensions are listed as:

Height 104 to 105.6 mm
width 64.3 to 65.9 mm
depth 33.3-34.9 mm

It is shown as a carbon -zinc type, but no current (amperage) or life
specs are given.

Best of luck in your quest,
Tim Schwartz


BoborAnn wrote:

I am repairing a Simpson model 1699 precision milliohm meter and found one
of these batteries in it. There was also a standard 9 Volt Battery which
leads me to believe the unit is 20-30 years old.
I've searched everywhere and can't find any info on this battery and was
hoping someone could advise what its characteristics were and why someone
would use this versus a standard D cell in this application.
Its about 1 1/4 X2 1/4 X 4 Inches and 1.5 V and bears no date code
This is a great meter and I'd like to find the right battery and not need
adapt a D Cell
Thanks in Advance
Bob

  #3   Report Post  
Jerry G.
 
Posts: n/a
Default

This battery type is long discontinued. If this is the old 22.5 Volt
battery. You can make one.

Get 15 of the small Lithium type watch batteries. Find a piece of small
cardboard or plastic tubing of the right diameter to hold the batteries
in series. Make a pressure contact to fit anb be fasened at each end.

This should serve as your battery for the meter. I have done this for
older photographic equipment and older radios.

Jerry G.

  #4   Report Post  
Bob Urz
 
Posts: n/a
Default



Jerry G. wrote:
This battery type is long discontinued. If this is the old 22.5 Volt
battery. You can make one.

Get 15 of the small Lithium type watch batteries.

Err, are not the open cell voltages of the lithium around 3 volts?
That would make it 7 or 8 cells to get close to 22.5 volts.
Maybe a CR2025/35 or such

You might see if this would work:
2725 EB-505 22.5 Volt Carbon Zinc Battery (505/M504/V74PX/W10)

http://cablesandconnectors.com/0030012.HTM

I also recall garage door opener batteries that are 12 volts, two
would give you 24 volts. There about the size of a AA only shorter.

We used to use a 22.5 volt cell in portable phantom power supplies
for microphones. They looked like a 9 volt on steroids. Cannot
remember the number though.

Bob

----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----
  #5   Report Post  
BoborAnn
 
Posts: n/a
Default

Its actually only a 1.5 Volt battery which is why its seems strange that
they would use such a large Battery If I can't find one I'll just try a D
Cell ( would probably try to get it into the original package so I wouldn't
need to mess with the mounting"
Bob
"Bob Urz" wrote in message
...


Jerry G. wrote:
This battery type is long discontinued. If this is the old 22.5 Volt
battery. You can make one.

Get 15 of the small Lithium type watch batteries.

Err, are not the open cell voltages of the lithium around 3 volts?
That would make it 7 or 8 cells to get close to 22.5 volts.
Maybe a CR2025/35 or such

You might see if this would work:
2725 EB-505 22.5 Volt Carbon Zinc Battery (505/M504/V74PX/W10)

http://cablesandconnectors.com/0030012.HTM

I also recall garage door opener batteries that are 12 volts, two
would give you 24 volts. There about the size of a AA only shorter.

We used to use a 22.5 volt cell in portable phantom power supplies
for microphones. They looked like a 9 volt on steroids. Cannot
remember the number though.

Bob

----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet
News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+
Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption
=----





  #6   Report Post  
Inty
 
Posts: n/a
Default


"BoborAnn" ha scritto nel messaggio
...
Its actually only a 1.5 Volt battery which is why its seems strange that
they would use such a large Battery If I can't find one I'll just try a D
Cell ( would probably try to get it into the original package so I

wouldn't
need to mess with the mounting"


Little watch batteries are 1.55V

I.


  #7   Report Post  
NSM
 
Posts: n/a
Default


"BoborAnn" wrote in message
...

Its actually only a 1.5 Volt battery which is why its seems strange that
they would use such a large Battery If I can't find one I'll just try a D
Cell ( would probably try to get it into the original package so I

wouldn't
need to mess with the mounting"


Just use the biggest cell that will fit and cobble something together to
make contact. If a D cell works use it.

N



  #8   Report Post  
BoborAnn
 
Posts: n/a
Default

I opened it up and found two cells about 1.5 X a D cell tied in parallel so
it must be ea high current application. Tomorrow I'll put a couple of D
Cells in parallel and mount them in the original battery box
Bob

news:83Bxe.126862$on1.120956@clgrps13...

"BoborAnn" wrote in message
...

Its actually only a 1.5 Volt battery which is why its seems strange that
they would use such a large Battery If I can't find one I'll just try a D
Cell ( would probably try to get it into the original package so I

wouldn't
need to mess with the mounting"


Just use the biggest cell that will fit and cobble something together to
make contact. If a D cell works use it.

N






  #9   Report Post  
Fred McKenzie
 
Posts: n/a
Default

In article , "BoborAnn"
wrote:

I opened it up and found two cells about 1.5 X a D cell tied in parallel so
it must be ea high current application. Tomorrow I'll put a couple of D
Cells in parallel and mount them in the original battery box


Bob-

That sounds about the size of an "F" cell. I would expect a modern
Alkaline D cell would have as much capacity as a carbon-zinc F cell.

Fred
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Help INfo on W-353 BAttery BoborAnn Electronics Repair 3 July 2nd 05 12:14 AM
Charging battery which is still connected Lem UK diy 8 February 3rd 05 10:43 AM
Sources of info to retrieve data off failing (failed) hard drives. Stellijer Electronics Repair 43 December 18th 03 07:01 PM
Jointech routerbits? Eric Ryder Woodworking 2 December 10th 03 11:33 PM
Car and Motorcycle Battery Tips Bill Darden UK diy 4 July 15th 03 03:49 PM


All times are GMT +1. The time now is 02:23 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"