Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Posted to rec.woodworking
external usenet poster
 
Posts: 1,821
Default 4 foot LED "shop" lighting



Just a rant ... a long one - sorry folks
but wondering if anyone else has any bad or good
experience with this type of lighting ?
And - buyer beware if you're outfitting your whole shop !

Less than a year ago, I installed a 4 ft. LED
self-contained plug-in light fixture in my back-basement
storage room. It was a very very decent looking item from
Lee Valley made by Armacost and more than double-the-cost
of the common cheapo units.
It failed last weekend ... after ~ 5 hours of ON time ! if that.
.... so much for the 10's-of-thousands-of-hours of LED bulb life !

I looked-it-over closely - checked the 120 volt cord & connectors -
everything was A-OK ; I pulled off the end-caps to check internal
wiring connectors A-OK ; pulled the ON-OFF switch ;
- everything was A-OK.

Guess what ? - Lee Valley doesn't carry them any more ;
Armacost says that it's discontinued and that it was probably
an internal power supply failure ... gee thanks !

The polite refund from Lee Valley meant that I was not out-of-pocket -
but it was little consolation - now I need to go shopping for
another fixture... again looking at the cheapo's that I avoided !

https://www.leevalley.com/en-ca/shop...?item=99W7681W

Plus - I'm hoping that the replacement fixture can be matched to
the custom-made little 45 degree corner-mounting-blocks
that I made for the original fixtures ...

Geeeze ! thanks for listening :-)

John T.



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
4 foot LED shop lights - radio interference [email protected] Woodworking 6 February 8th 20 03:41 PM
How to prune the top of a 30 foot oak tree so it's a 20 foot tall oak tree Bob-tx[_3_] Home Repair 0 July 5th 11 09:49 AM
selling led lighting such as led christmas light,led decorative light,led house lamp led lighting UK diy 0 February 6th 07 06:45 AM
LED,LED Lamp,LED Lights,LED Display,Automotive Lamp,LED Chip,LED Module [email protected] Electronics 0 December 4th 05 11:08 AM
8 FOOT vs. 4 FOOT WARRENRN1 Woodworking 11 March 22nd 04 07:19 PM


All times are GMT +1. The time now is 03:45 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"