Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Vise jaw problem?
Hi guys,
I just screwed up and I am kind of ticked off. What a moron I am and I don't even know how I made the mistake. I bought a large front vise from Lee Valley to put on my workbench. I cut the front and rear jaws, I used the template that came with the vise to bore all my holes for the guide rods etc and I go to put it on my workbench and my holes are drilled in the wrong place........arrrrgh. I am now short about 1/4" on the top edge of both my jaws so they are not flush with the top of my bench. Does anyone see any reason why I couldn't laminate a 1/4" edge to the top edge of both jaws or would that create a weak spot? It would be a shame to start all over since it was the nicest pieces of birch I could find in my shop. Regards. -Guy |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Wiring problem | Home Repair | |||
Got a decent vise; what a difference! | Woodworking | |||
Problem with new water heater (electric) - please advice | Home Repair | |||
RCA tv 36" color problem | Electronics Repair |