About Us

[email protected]

On Fri, 31 Jan 2020 16:11:45 -0500, Clare Snyder
wrote:

On Fri, 31 Jan 2020 15:35:49 -0500, wrote:

I want to place two 4 foot LED slim lights in my long narrow cold
room - top corner, 1 per side, staggered -
- a couple "plastic" 45 degree mounting blocks for each light
would allow them to be angled out from the top corner and provide
a bit of a thermal / moisture break from the concrete.
I'm trying to avoid wood - the cold room can get pretty damp at
times and I don't want to promote mold/mildew.
I'm thinking a piece 4 " square x 1.5 " thick would be cut in half
diagonally to make 2 mounts.
Buying thick HDPE or phenolic is a bit pricy for this job -
any suggestions for a similar - but cheaper - product ?
Even re-purposing a common cheap item ... ?
Treated wood might be my final solution - but I thought I'd pick
your brains first.
John T.

Trex? cut and laminated with construction glue? Or get a friend with a
3D printer?
Or contact Fusion Thetics in Fergus Ontario for a "sample" of their
product.
Or check with Plasticlumberyard.com in the 610 area code (Pa)

Thanks.
Gives a whole new meaning to plastic wood ! :-)

http://fusionthetics.com/plastic-lumber/

John T.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Machining HDPE question	Wes[_5_]	Metalworking	12	October 2nd 10 12:53 AM
OT HDPE/UHMW polyethylene?	John Doe	Metalworking	9	March 21st 08 05:24 AM
machining HDPE to high finish	Lloyd E. Sponenburgh	Metalworking	3	May 3rd 06 01:05 AM
Sources for UHMW or HDPE	Rob V	Woodworking	8	September 15th 05 03:21 AM
Source for 3" thick HDPE sheet or bar?	DeepDiver	Metalworking	4	June 4th 05 10:54 PM