[[email protected]]

I am making my mom a rather large cutting board as she needs it. between 2ftx2ft and 3ftx3ft. (Need to measure her counter.)

It will be made of hard maple. She wants it flat (no feet) so she can use both sides.

I was wondering if I could use 3/8 stainless all thread through it to decrease the likelihood of warping. Or will this just cause more problems?

If I use all thread, should I use a tap and thread the holes the all thread goes through? Should I drill and install the all thread once it is glued? Should I use glue on the all thread?

I will have to make this in "sections" then install the sections together. (My planer is not big enough to plane the entire piece.

Any advice from you experts is appreciated!