Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Boeshield T9 Problem
After reading the good reviews of Boeshield T9 rust preventative, I
bought some at a wood working show. My new general tablesaw had been sitting in my garage since I bought it about a month ago. After cleaning up the gunk manufacturers put on the machines to avoid rust, it didn't have any protective layer on it, and it looked fine a month later. Then I bought the Boeshield. Before putting it on, I rubbed the table down with naphtha, after which I sprayed Boeshield on and wiped most of it off. The next day I had rust. I cleaned all of it off with mineral spirits and re-applied Boeshield. Again, the next day I had rust. I called the company and was just told to "put it on thicker." After being bitten twice, I'm hesitant to go through it again. Anyone have any theories? I'm leaning towards simply using Johnson paste wax on the table top. -Peter De Smidt |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Quick Change TP problem | Metalworking | |||
jointer problem | Woodworking | |||
Boiler Problem Gradually Getting Worse | UK diy | |||
Problem with JET Supersaw problem | Woodworking | |||
Sears air compressor starting problem | Woodworking |