Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
Source for mini newels needed
I'm looking for a supplier of newels or balusters 1" square with a length on
approx 12". I'd like a newel profile similar to the 3500-BT, 3503-BT or the 3505-BT, just on a smaller scale. Most newels are 3-4" square, balusters are normally 1-1 3/4" square, but, 30+ inches and probably would scale down properly for my needs. Oak is preferred. I guess if all else fails, it may be a good reason to look into a lathe... Ron |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Try this Gunner | Metalworking | |||
View Source virus.... | Electronics Repair | |||
OT - Delay, Delay | Metalworking | |||
OT : Source for printer control codes needed | UK diy | |||
Source of Roll Vent or similar ridge ventilation needed | UK diy |