Home |
Search |
Today's Posts |
|
Woodturning (rec.crafts.woodturning) To discuss tools, techniques, styles, materials, shows and competitions, education and educational materials related to woodturning. All skill levels are welcome, from art turners to production turners, beginners to masters. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem with my Oneway 2436
Today I was finishing a small bowl on my lathe and when I attempted to
increase the speed nothing happened. I reset it to no avail. Anyone have similar problem and know the fix? Thanks |
#2
|
|||
|
|||
Problem with my Oneway 2436
Pull the two leads from the door switch and connect them, by passing the
switch. If that doesn't work, is the emergency button on the control panel locked in the in position. If that's not it - what error message is being displayed on the inverter, i.e. E6. "Paul Rasmussen" wrote in message ... Today I was finishing a small bowl on my lathe and when I attempted to increase the speed nothing happened. I reset it to no avail. Anyone have similar problem and know the fix? Thanks |
#3
|
|||
|
|||
Problem with my Oneway 2436
It is going slow, no error message on inverter. Wondering if the rheostat.
"Raymond Odi" wrote in message . ca... Pull the two leads from the door switch and connect them, by passing the switch. If that doesn't work, is the emergency button on the control panel locked in the in position. If that's not it - what error message is being displayed on the inverter, i.e. E6. "Paul Rasmussen" wrote in message ... Today I was finishing a small bowl on my lathe and when I attempted to increase the speed nothing happened. I reset it to no avail. Anyone have similar problem and know the fix? Thanks |
#4
|
|||
|
|||
Problem with my Oneway 2436
Hello Paul,
Please call me at 1-800-565-7288 and I will do my best to get you fixed up. If the lathe is not changing speed the speed pot has probably gone bad. If so we can reprogram the drive to take the speeds from the keypay, this is a bit of a pain but keeps you going until we can get you a replacement part. If the lathe has gone to minimum speed and will not speed up one of the wires may have become disconnected at either the speedpot or drive. regards Kevin |
#6
|
|||
|
|||
Problem with my Oneway 2436
Kevin was right on it, spent quite a bit of time on telephone with us
attempting to id and correct the problem. Apparently an unusual problem so needed to send the drive back to Oneway for repair. "simcha evron" wrote in message om... (Kevin) wrote in message . com... Hello Paul, Please call me at 1-800-565-7288 and I will do my best to get you fixed up. If the lathe is not changing speed the speed pot has probably gone bad. If so we can reprogram the drive to take the speeds from the keypay, this is a bit of a pain but keeps you going until we can get you a replacement part. If the lathe has gone to minimum speed and will not speed up one of the wires may have become disconnected at either the speedpot or drive. regards Kevin thats what i call good service. well done kevin. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Quick Change TP problem | Metalworking | |||
jointer problem | Woodworking | |||
Boiler Problem Gradually Getting Worse | UK diy | |||
Problem with JET Supersaw problem | Woodworking | |||
Sears air compressor starting problem | Woodworking |