Hi all.
I'm fitting a couple of speedfit manifolds at the weekend.
Whats the technique to fitting these?
Is it just push or twist and push?

Thanks.

Arthur

"Arthur" wrote in message
...
Hi all.
I'm fitting a couple of speedfit manifolds at the weekend.
Whats the technique to fitting these?
Is it just push or twist and push?


A bit of both :-). Just practice a bit beforehand in an easy position to
make sure you get the technique right. If it ain't home fully it will
fail - it's just a matter of when.

"Mike" wrote in message
...

"Arthur" wrote in message
...
Hi all.
I'm fitting a couple of speedfit manifolds at the weekend.
Whats the technique to fitting these?
Is it just push or twist and push?


A bit of both :-). Just practice a bit beforehand in an easy position to
make sure you get the technique right. If it ain't home fully it will
fail - it's just a matter of when.



Thanks.

I assume I would practise by pushing in the pipe without the pipe insert.
If I use the pipe insert do I have just one 'go'

Is the manifold totally reusable?

Arthur

"Arthur" wrote in message
...

"Mike" wrote in message
...

"Arthur" wrote in message
...
Hi all.
I'm fitting a couple of speedfit manifolds at the weekend.
Whats the technique to fitting these?
Is it just push or twist and push?


A bit of both :-). Just practice a bit beforehand in an easy position
to
make sure you get the technique right. If it ain't home fully it will
fail - it's just a matter of when.

I assume I would practise by pushing in the pipe without the pipe insert.
If I use the pipe insert do I have just one 'go'

Is the manifold totally reusable?

Supposed to be I believe. I normally use Polyplumb but use Speedfit for end
stops as they are re-useable (Polyplumb isn't) though sometimes the insert
stays inside.