"David WE Roberts" wrote in message
...


Meanwhile we wait for everything to dry out before fitting the new hard
tray - which has to be on a plinth because the old shower tray was very
deep and we don't want to move the shower cubicle (hang on - we probably
could.....perhaps not...ummmm) but anyway on something of a plinth to
allow the pipework to exit using the old route.

Fitted 2 new cast stone bases in my build ... pre-built 100x50 support frame
with 20mm ply on top.
I used HepVo traps as they are perfect for under showers ... no S/U or P
bend to worry about. (they also serve as AAVs)

I bedded the trays down on a 4:1 semi-dry cement mix.

The shower waste outlets were proper shower ones ... i.e. the centre lifts
out and has a 'hair' trap for stopping bits going going pipework.