Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 347
Default OT Car won't start

Helping neighbor with 1996 Dodge Intrepid. Car quit suddenly while on
highway. Obviously, it won't start.

Replaced the following: (Auto wrecker lets us return parts for up to 30
days) (We pulled the parts ourselves)

Cam position sensor
Crankshaft position sensor
Coil
Power train module computer
Auto Shutdown Relay

We did the above after following all the diagnostics in the Chilton's
manual. BTW, the wires to both sensors (cam & crankshaft) have the correct
signal voltage (9± volts) with ignition on. No spark coming to plugs.

Any and all help diagnosing this would be greatly appreciated.

Ivan Vegvary

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Kick start vs pull start steamer Metalworking 17 January 17th 08 07:36 PM
PC won't start Jill Electronics Repair 9 January 17th 06 04:40 AM
$10,000 to start Tom Nie Woodturning 42 July 28th 05 01:05 AM
If you were to start again, how would you do it? shedfull Metalworking 3 May 21st 05 12:36 PM
Kenmore dryer 2002 Push to start will start motor but will not stay on. Doug Home Repair 2 August 18th 04 11:32 PM


All times are GMT +1. The time now is 10:03 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"