 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
How do you cut off Cobalt tool bits to length?
I have a 2" long, 1/4" square Cobalt tool bit I have ground for cutting
internal threads with a boring bar. The bit is too long to fit in the hole in the work. My Dremel cut off wheel is very slow, and grinding an inch off would be worse. TIA -- Be careful what you pray for, it can happen. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| wooden tool handle finishing | Woodworking | |||
| Hand Tool Behavior - The Psychology of Hand Tools | Woodworking | |||
| Surface finish | Metalworking | |||
| The New Ridgid power tool Warranty | Woodworking | |||
| Musings on Tool Sets (Apologies to Arch) | Woodturning | |||
Threaded Mode
