Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Do sprag clutch bearings work together?
If you put two sprag clutch bearings into a scooter wheel to replace
ordinary 608 bearings, will they work together? In other words... Will both bearings share the load equally? Will both bearings lock at exactly the same time/location? That's how it looks to me, but I have no experience with them. Thanks. |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Do sprag clutch bearings work together?
John Doe fired this volley in news:lor0cv$58p
: Will both bearings lock at exactly the same time/location? If they're loaded sprags (that is, the rollers are held with light pressure against the ramps at all times), yes. Even if they don't, they'll wear until they do. The one doing all the locking will wear faster than the other one. LLoyd |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT - Ford fan clutch | Metalworking | |||
Kaydon Bearings Ulta slim bearings - cost is prohibitive -Alternative supplier?? | Metalworking | |||
one-way clutch---again | Metalworking | |||
Where can I see a 'dog clutch'? thanks | Metalworking | |||
Ryobi Strimmer? Clutch or no clutch? | UK diy |