Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
The stronger
I want to put some lateral pieces under my trailer frame to stiffen it.
They will run from side to side, and weld on. My choices are channel, heavy angle, I beam, and hitch stock. Which would be better in terms of supporting sag, and holding up weight over a 77" span? Thanks Steve |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
The stronger
http://en.wikipedia.org/wiki/Case_hardeningOn Thu, 24 Oct 2013 09:24:47 -0700, SteveB wrote:
I want to put some lateral pieces under my trailer frame to stiffen it. They will run from side to side, and weld on. My choices are channel, heavy angle, I beam, and hitch stock. Which would be better in terms of supporting sag, and holding up weight over a 77" span? Thanks Steve I beam has the best load bearing. But there may be other factors. I used Channel on my truck bed rebuild becase I wanted to weld in a stake pocket on each cross support. And a 5th wheel support in the center. Also needed channel for the front back and sides. So doing the whole thing out of channel was best. Karl |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
The stronger
On 2013-10-24, SteveB wrote:
I want to put some lateral pieces under my trailer frame to stiffen it. They will run from side to side, and weld on. My choices are channel, heavy angle, I beam, and hitch stock. Which would be better in terms of supporting sag, and holding up weight over a 77" span? I would use channel. But keep in mind, your trailer with its tires, axles and suspension, was designed for a certain weight capacity. If you make the bottom stronger, that does not mean that the trailer can carry more weight. Actually less, since you added the deadweight of the supporting members. i |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Are Chevy Duramaxes stronger than Ram? | Metalworking | |||
Anyone know if the HD tv signal will be stronger? | Home Repair | |||
Stronger solder? | Electronics Repair | |||
Which is stronger? | Woodworking | |||
which engine stronger | Home Repair |