Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 1,620
Default Clip Bearings Source

I need a few of the 3/16 x 1/16 version:

https://sdp-si.com/eStore/GroupHead.asp?GroupID=1089

Stock Drive has 'em for $0.55, but they also have a service change
(unknown) for orders less than $50.00

McMaster has the version for thicker panels (.072 to 0.14 or something),
for $1.50. So, 3x expensive (excluding service charge) and not quite
right.

Anyone know any other places that have these? Suggestions of where to
look? I'm thinking I may just get some from Stock Drive and eat the
service charge, but I'd like to know what it is!

--
My liberal friends think I'm a conservative kook.
My conservative friends think I'm a liberal kook.
Why am I not happy that they have found common ground?

Tim Wescott, Communications, Control, Circuits & Software
http://www.wescottdesign.com
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Source for loose 3mm ball bearings needed Tom Gardner[_2_] Metalworking 5 March 21st 08 09:57 PM
Looking for Source for small thrust bearings John2005 Metalworking 10 December 14th 07 02:21 AM
Kaydon Bearings Ulta slim bearings - cost is prohibitive -Alternative supplier?? Mike Johns Metalworking 5 October 26th 07 05:18 PM
Source for Router Bearings [email protected] Woodworking 0 January 22nd 05 01:28 AM
Source for broze bearings Joe-46er Home Repair 7 December 11th 04 04:02 AM


All times are GMT +1. The time now is 09:30 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"