Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
|
LinkBack | Thread Tools | Display Modes |
#41
Posted to rec.crafts.metalworking
|
|||
|
|||
Just checkin' in
|
#42
Posted to rec.crafts.metalworking
|
|||
|
|||
Just checkin' in
On Mon, 25 Jul 2011 17:17:23 -0700, pyotr filipivich
wrote: on Mon, 25 Jul 2011 23:10:00 +0800 typed in rec.crafts.metalworking the following: New residence should be completed about the end of August, then I can get my workshop set up in my half of the shed. You need a bigger shed. B-) I agree, but the local council will not allow a larger shed on the property without going through a full council meeting to obtain planning approval, paying extra fees and all the nearest 5 neighbours on each side agreeing. If we had gone for a smaller shed approval would have been immediate. We went for 10% over or 180 square metres instead of the supposed maximum of 165, which was the maximum "oversize" permitted for "drones" discretion. Just for your interest, this is it. http://www.nearmap.com/?ll=-32.19100...h&nmd=20110420 map has not been updated since April Alan |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Just checkin' ... | Electronics Repair | |||
Steve Still doin ok? Just Checkin! | Woodworking |