Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Looking for Tooling
What's that Lassie? You say that Joe AutoDrill fell down the old
rec.crafts.metalworking mine and will die if we don't mount a rescue by Thu, 1 Jul 2010 13:37:23 -0400: Not worried where the plugs go. It's a manually loaded part with a trigger for the drill process. But it's like a drill press on steroids in that it will never be turned off while they are drilling parts and has enough thrust to crush the part... I'll manage the feed, RPM and thrust rates. It's all about that plug. Forstner bits were suggested by the woodworkign folks, but I'm afraid that the plug may stick to the center pilot even on that set-up. Tests to follow. We shall see... As for the other custom tool ideas discussed here already - too fancy for the customer "me thinks"... They want an off-the-shelf, inexpensive oepration for a downa nd dirty, low tolerance required hole process. I don't think he would care if the plugs ejected 10' away as long as he could put up a wall to stop them. If you don't need a pilot hole to guide the hole saw, then you may be able to get away with a half hole saw. Just take a hole saw, and grind away a little more than half of it. That should keep it from holding onto the slug. You will need to adjust the feed rate and you may need to add some weight to keep it in balance depending on your spindle. -- Dan H. northshore MA. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
#50 NMTB tooling available | Metalworking | |||
Used tooling in San Diego, CA??? | Metalworking | |||
Lathe Tooling? | Metalworking | |||
Tooling up for SMT | Electronics Repair | |||
New tooling for an old lathe | Metalworking |