Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Larios Horizontal mill and shop straightening
On Fri, 05 Mar 2010 21:50:25 -0800, the infamous Gunner Asch
scrawled the following: Notice the control panel in photo 16. So, do the Eyetalyuns hire good looking women in short skirts to run their mills? Floor-level is an assinine position for that CP. -- The blind are not good trailblazers. -- federal judge Frank Easterbrook |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Larios Horizontal mill and shop straightening
On Sat, 06 Mar 2010 07:44:09 -0800, Larry Jaques
wrote: On Fri, 05 Mar 2010 21:50:25 -0800, the infamous Gunner Asch scrawled the following: Notice the control panel in photo 16. So, do the Eyetalyuns hire good looking women in short skirts to run their mills? Floor-level is an assinine position for that CP. One would hope so! Ive always considered a corner to be a good place for most mills. Using that one in a corner would be a head bumping nightmare. Gunner Whenever a Liberal utters the term "Common Sense approach"....grab your wallet, your ass, and your guns because the sombitch is about to do something damned nasty to all three of them. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Horizontal mill for sale | Metalworking | |||
Horizontal mill question | Metalworking | |||
Barker Horizontal Mill | Metalworking | |||
Horizontal mill: regular arbor cutters or end mill adapter? | Metalworking |