View Single Post
  #2   Report Post  
Posted to rec.crafts.metalworking
Gunner Asch[_6_] Gunner Asch[_6_] is offline
external usenet poster
 
Posts: 10,399
Default Larios Horizontal mill and shop straightening

On Sat, 06 Mar 2010 07:44:09 -0800, Larry Jaques
wrote:

On Fri, 05 Mar 2010 21:50:25 -0800, the infamous Gunner Asch
scrawled the following:

Notice the control panel in photo 16.


So, do the Eyetalyuns hire good looking women in short skirts to run
their mills? Floor-level is an assinine position for that CP.



One would hope so!

Ive always considered a corner to be a good place for most mills. Using
that one in a corner would be a head bumping nightmare.

Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.