Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 10,530
Default Mag light corrosion (some metal content)

I recently had a battery corrode in my black
4D cell Mag light. Old style bulb, if that's
relevant.

The 4D mag light by my front door was dead. I
managed to get the tail cap off (two big pipe
wrenches) and find the bottom battery had
corroded. Brand new battery, Endurance, from
Advance Auto Parts. After considerable scrubbing
and sanding, the light works again. I'm leaving it
in peices over night to dry. Then load up with
four Rayovac cells, and a shot of grease on the
tail cap threads.

The 4D mag is my "grab and go" light, in case I
need to go some where in a hurry.

It was only happy coincidence that I found the
corroded battery. Might have been there for
years, if I'd not needed the light for a bulb
test.

Since that time, others have told me that
batteries
corrode only in D cell mags, and typically the
battery next to the tail cap. Has anyone else
had this happen? Is it a common problem?

--
Christopher A. Young
Learn more about Jesus
www.lds.org
..



 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
SOME metal content Bob La Londe Metalworking 3 October 5th 09 05:53 AM
New Metal Content Pete Snell Metalworking 3 July 28th 09 06:02 PM
Somewhat OT but has some metal content [email protected] Metalworking 20 July 28th 08 01:07 AM
OT - but some metal content Bruce in Bangkok[_3_] Metalworking 15 April 21st 08 02:02 AM
You might be a gun nut...(metal content) Gunner Metalworking 19 January 18th 06 04:11 AM


All times are GMT +1. The time now is 11:09 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"