Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
I'm stumped with a pump
I have a small cast iron, gear pump that was working.
The gear is about an inch in diameter, .375 thick and the other gear (idler type) is a bit smaller. No blockages, no clogs, all looks good. However, there are three set screws/plugs around the periphery of the pump equidistant at 120 degrees. This thing no longer pumps but tries to do so. There are no leaks. I did fiddle with the plugs as it was not doing well. Help, anyone? Thanks j/b |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Stumped on home repair of GFCI circuit all dead after light repair | Home Ownership | |||
Problem that stumped plumbers | Home Repair | |||
New central AC odor - stumped | Home Repair | |||
Electrical Problem has me stumped .. .. .. | Home Repair | |||
Getting Stumped-air in line to toilet | Home Repair |