Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
WTB 220 /240 Vac 3 ph AFC, 1 ph input
Since my apprentice days I have always been fascinated by gear
hobbing, and I finally did it! I purchased 3rd hand from an acquaintance of a friend an ALFRED GAUTHIER gear hobbing machine, little used and in excellent condition. Got most if not all change gears, operating instructions in German, a box full of hobs mostly 48 DP 14 1/2 and 20 deg. helix angle, some 64 DP, several 32 DP, 80! DP, 105! DP, and a bunch of metric MODULE hobs....a really cute little machine that fits naturally into my work shop. I WILL have to make work-holding mandrells, only these were missing. Usually they are custom made to suit the job-at-hand. Work envelope is 2 3/8" work dia.max (60 mm) x 1 1/2" (40 mm) long, fully automatic after initial setup. It also appears easy to set-up, gear boxes -3 of them- are easily accessible. The motor is 1/3 HP, 220/230 Vac, 3 ph 50 Hz. I have 220 Vac 1 ph available and would like an appropriate VFD to make it hum. I thought a 1/2 HP, 1 ph input unit would be the cat's meow. Does anyone have such a unit laying about crying out to "find me a good home"??? Iggy, do you fit the bill here? I live in SW Ontario, Canada, and would appreciate advice, availability, location, $$$$, etc. Many thanks for your efforts here! Wolfgang |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT - Need Vehicle Input | Woodworking | |||
No RF input on a TV. | Electronics | |||
Thanks for all your input... | Metalworking | |||
T V Projectors --- Looking for input | Electronics Repair | |||
"Need input" | Woodworking |