 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Help with centrifugal clutch
hello all
I need to buy a centrifugal clutch for motorizing my bike. The engine is a 31cc weedeater (yes I know those are not the best for this). My doubt is that the clutches commonly available (mainly Comet, 4 inches) usually are rated rated 2.5 to 6 HP. I guess my engine can put about 1 HP., perhaps 1.5 HP at most. Is the engine underpowered for these clutches? I could get a trimmer clutch but then the clutch seem to be small for the task. Thanks in advance Camilo *** Posted via a free Usenet account from http://www.teranews.com *** |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Atlas Lathe feed screw clutch adjustment | Metalworking | |||
| one-way clutch questions | Metalworking | |||
| Adding A Bit More To My Recent Post Re Weed Wackers/Line Trimmers | Home Repair | |||
| sticky transmission clutch | Metalworking | |||
| Dyson DC04 brush bar clutch | UK diy | |||
Threaded Mode
