 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
expanding an off center hole
Hello RCM'rs.
If you have an existing 1/4" dia hole (1/2" deep), and want to drill a new hole of 1/2" dia and offset it .040" from the center of the 1/4 hole but you only have a drill press how would you do it? Right now I'm thinking of trying a drill bushing correctly oriented over the part and just trying a twist drill but was hoping there is a better way ( I would normally try plunge cut will mill). TIA for any comments. AL |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Inner Diameter of Hole Too Large for Press Fit | Metalworking | |||
| Drilling holes Correcting mistakes in hole locations | Metalworking | |||
| taper turning betw. centers | Metalworking | |||
| Dead center/live center lathe question | Woodworking | |||
| Jacobs Chuck on Jet Mini Lathe | Woodturning | |||
Threaded Mode
