Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #5   Report Post  
Posted to rec.crafts.metalworking
Andrew Mawson
 
Posts: n/a
Default Colchester Student Mk 1 - some questions


"Mike Berger" wrote in message
...
They came with both 3-phase and single phase motors, but since the
Student MK I was intended for home/small shop use 3 HP sounds pretty
big.

Austin Shackles wrote:

All it needs then is a decent sized motor. Currently has a 1.5HP,

which is
not really enough - ISTR the student originally had a 3HP motor.


The Colchester Student was NEVER intended for home use !!!!!!

Schools, colleges and aprentice training schools yes. Small shop yes.

AWEM




 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
TS Setup/alignment questions Mike W. Woodworking 43 March 31st 05 12:21 AM
PEX Fresh Water system/repipe questions -l ong BobK207 Home Repair 1 March 13th 05 10:37 PM
More gas questions Ralph D. Home Repair 10 February 13th 05 08:37 AM
Questions about Pest or Termite Control [email protected] Home Ownership 0 November 2nd 04 06:34 AM
Questions about Pest and Termite Control [email protected] Home Repair 0 November 2nd 04 06:30 AM


All times are GMT +1. The time now is 08:22 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"